glauconite

views updated May 08 2018

glauconite Although sometimes considered as clay mineral, glauconite is more accurately a member of the mica group, with the composition (K,Ca,Na)<2(Fe3+,Al, Mg,Fe2+)4[(Si,Al)4O10]2(OH)4; sp. gr. 2.4–3.0; hardness 2; monoclinic; olive green, yellowish, or blackish green; dull lustre; granular; occurs in marine sediments as aggregates up to 1 mm in diameter. It is being formed on many modern continental shelves, at depths from a few tens to hundreds of metres, where the sedimentation rate is low and decaying organic matter is present in a generally oxidizing environment. In many sandstones glauconite can impart a green colour when abundant, as in the Cretaceous Greensands of Britain and the eastern USA.

Phyllosilicates

views updated May 18 2018

Phyllosilicates

Phyllosilicates are a group of minerals that are fundamentally composed of extended flat sheets of linked silicon-oxygen tetrahedra. Included in the phyllosilicate family are micas and clays. The name is derived from the Greek word phyllos, meaning leaf. As the name implies, phyllosilicates often display a platy or flaky crystal habit or perfect planar cleavage.

The phyllosilicate structure consists of sheets of hydrated SiO4 rings (they are hydrated because there is one hydroxyl ion [OH] in the middle of each ring) and an octahedral sheet consisting of AlO or MgO. The simplest phyllosilicate is a sole octahedral layer: brucite in the case of MgO, gibbsite if the octahedral layer is AlO. However, most phyllosilicates are composed of interlocking tetrahedral and octahedral layers combined in the ratio of 1:1 or 2:1. One tetrahedral layer linked to one octahedral layer yields the 1:1 structure. This forms kaolinite when an AlO octahedral layer is used, antigorite if the octahedral layer consists of MgO. Other clay minerals such as talc and pyrophyllite are composed of a 2:1 structure: two tetrahedral layers sandwiching one octahedral layer. In both structures, 1:1 and 2:1, a weak residual interlayer charge exists. This interlayer charge is the source of the van der Waals forces that hold each interlocked layer to one another. These weak interlayer bonds are easily broken and allow the sheets to slip, resulting in the low hardness and greasy feel that is typical of clays.

Other phyllosilicate minerals are derived from further complications of the interlocking sheet system. For example, the micas are formed when atoms of aluminum substitute for silicon in the tetrahedral layer. Because these two elements carry different charges, the net charge of the 2:1 layers is increased. The result is an interlayer bond that is stronger than a van der Waals forces and produces the perfect planar cleavage and slightly higher hardness of micas.

See also Clay; Phyllite