hCG protocol: mixing hCG for desired dose. See vid response for spread sheets

WWW.HCGPROTOCOL.COM - REASONABLE kit prices. Even if you don't order, check out the nostalgia & Links pages. If you've found this info helpful, PLEASE use coupon code 98904 when ordering the hCG from drugdelivery.ca... I just started a site that sells kits for the protocol supplies - by spreading out the shipping charges I can usually offer them cheaper than you can order them directly. Thanks and best of luck! Ahhh, high school math - who didn't love it?! Anywhoo - using cross multiplication & division... you can successfully calculate how to mix your hCG. Known values will be your strength of amps & daily dose - you can dilute as much as you like, as mentioned I like to keep daily doses in the 0.3cc - 0.5cc range, though I've heard some people mention they were doing 1.0cc per day. As long as you calculate correctly prior to mixing, both are correct. When I say to keep an "odd" amount as the initial diluent - say you have 2000IU & want to take 150IU per day - you throw out a guesstimate of 5ml in as the diluent, and find daily doses would be 0.375cc... no way to accurately measure that amount in a syringe, but it gets you in the ball park. Round the daily volume up to 0.4cc - 0.4 x 2000 = 5.33ml (easier to measure an odd amount ONCE to mix the amp than EVERY day for daily doses) - that's just as an example, in the case above the most accurate way is to add 4ml to the hCG & use 0.3cc per day OR 8ml & use 0.6cc per day. Double check your results for accuracy PRIOR to mixing... if you're using 2000IU amps & 200IU per day - you know off the bat that when it's said & done you should have TEN daily doses... 1/10th of your total diluent will be your daily dose - 1/10th of what total amount is up to you. I wouldn't go less than 0.3cc with a 1cc syringe as it's impossible to be accurate, and wouldn't go above 1cc because it simply isn't necessary. When using higher concentrations of hCG - the easiest way to mix is to calculate your amount of diluent, REMOVE the remainder from a fresh vial of 30ml bacteriostatic water, inject 2-3ml into the amp, then aspirate the whole of it & inject into the same 30ml vial. PLEASE cleanse the vial stopper with a fresh alcohol pad prior to any needle insertion, either mixing or measuring your daily doses. Hope this helps. Laters. Tim DelMem