Comparative Study of Continuous-Power and Pulsed-Power Microwave Curing of Epoxy Resins. From: Polymer Engineering and Science | Date: October 1, 2000| Author: FU, BAO; HAWLEY, MARTIN C. | COPYRIGHT 2000 Society of Plastics Engineers, Inc. This material is published under license from the publisher through the Gale Group, Farmington Hills, Michigan.  All inquiries regarding rights should be directed to the Gale Group.Copyright information

MARTIN C. HAWLEY [*]

Three epoxy reaction systems, diglycidyl ether of bisphenol A (DGEBA) with curing agents meta phenylene diamine (mPDA), diaminodiphenyl methane (DDM), and diaminodiphenyl sulfone (DDS), were cured with both pulsed-power and continuous-power microwave curing systems. Isothermal curing was conducted at three different temperatures for each reaction system with both pulsed-power and continuous-power microwave curing systems. Extent of cure was measured ...

Related newspaper, magazine, and journal articles from HighBeam Research

	Comparative Study of Continuous-Power and Pulsed-Power Microwave Curing of Epoxy Resins. Polymer Engineering and Science ; MARTIN C. HAWLEY Three epoxy reaction systems, diglycidyl ether of bisphenol A (DGEBA) with curing agents meta phenylene diamine (mPDA), diaminodiphenyl methane (DDM), and diaminodiphenyl sulfone (DDS), were cured with both pulsed-power and continuous-power microwave curing systems. Isothermal
	Feedback Microwaves & RF ; Incorrect Statements (continued from last month) >> THE REFLECTED WAVE is not "absorbed" by the source. What happens is that the reflected wave is rereflected at the source while adding to the incident (forward) power on the transmission line. The power absorbed by the load is equal to the
	A mathematical evaluation of dose-edpendent PpIX fluorescence kinetics in vivo Photochemistry and Photobiology ; A Mathematical Evaluation of Dose-dependent PpIX Fluorescence Kinetics In Vivo(par) ABSTRACT The in vivo pharmacokinetics of protoporphyrin IX (PpIX) after administration of 5-aminolevulinic acid (ALA) cannot be described accurately by mathematical models using first-order rate processes. We have
	Monitoring of Hydrogenation with Various Catalyst Ratios JAOCS, Journal of the American Oil Chemists' Society ; ABSTRACT: Soybean oil was hydrogenated using two different nickel-based commercial catalysts (Nysosel 222 and SP-10) at various ratios in 4-L reactors under constant conditions (165C, 2 bar hydrogen pressure, and 500 rpm stirring rate). Trans isomer formation, reaction rates, selectivity (S)
	Heterogeneous photocatalytic oxidation of nitrotoluenes Water Environment Research ; ABSTRACT: The photocatalytic oxidation rates of nitrotoluene (2NT and 3-NT) and dinitrotoluene (2,4-DNT and 2,6-DNT) in aqueous suspensions of Degussa P-25 were found to be pH independent because these compounds do not exhibit any pH-dependent speciation. The reaction rates of mononitrotoluenes
	Correction to D. Ghosh: Metall. Mater. Trans. B, 2005, vol. 36 Metallurgical and Materials Transactions ; "Discussion of 'The Influence of Chemical Equilibrium on Fluid-Solid Reaction Rates and the Falsification of Activation Energy After this article printed, an error was noticed in the submission date. The correct submission date is May 2, 2005.
	Kinetics of association of anti-lysozyme monoclonal antibody D44.1 and hen-egg lysozyme Biophysical Journal ; ... two-dimensional contour electrostatic potential maps are shown, for the wild-type fragment ... mutations E35Q and E50Q (d). Potential maps were produced, slicing with z-plane through ... kept for the antibody fragments in all maps of Fig. 2. The red color shows negative ...
	Tetrameric Mouse Acetylcholinesterase: Continuum Diffusion Rate Calculations by Solving the Steady-State Smoluchowski Equation Using Finite Element Methods Biophysical Journal ; ABSTRACT The tetramer is the most important form for acetylcholinesterase in physiological conditions, i.e., in the neuromuscular junction and the nervous system. It is important to study the diffusion of acetylcholine to the active sites of the tetrameric enzyme to understand the overall signal
	Reaction and evaporation rates of high temperature candidate fluids from a TFOST test Tribology Transactions ; ... high temperature application. Degradation maps were constructed for each individual lubricant ... RESULTS AND DISCUSSION Lubricant Degradation Maps The quantity of remaining lubricant in ... candidate fluids. Lubricant degradation maps were constructed to show the recorded experimental ...
	Comparison of Two Palladium Catalysts on Different Supports During Hydrogenation JAOCS, Journal of the American Oil Chemists' Society ; ABSTRACT: Soybean oil was hydrogenated using two different palladium-based catalysts, 5% palladium on carbon (Pd/C) and 10% palladium on alumina (Pd/A), at various ratios in a 4-L reactor under constant conditions (165C, 2 bar H^sub 2^, and 500 rpm stirring rate). Reaction rate, frans isomer

See all results.