International Journal of Applied Engineering Research - Articles

14 total articles

International Journal of Applied Engineering Research Journals - HighBeam Research has hundreds of International Journal of Applied Engineering Research journals and millions of articles all in one library.

Articles from back issues of International Journal of Applied Engineering Research

2007

  1. January 2007

    Recently added articles from International Journal of Applied Engineering Research:

    Lightning protection of structures and electronic equipment: a case study.(Report)

    Jan 01, 2007; Okyere, P.Y. ... Abstract Lightning-related damages to structures and electronic equipment can be mitigated by following lightning protection techniques recommended in recognized national and international standards. However, field engineers in many parts of the world doubts the effectiveness of ...

    An effective asynchronous micropipeline using double edge triggered D Flipflop.(Report)

    Jan 01, 2007; Mohideen, S. Kaja ... Abstract This paper presents the design and simulation results of asynchronous micro pipeline using an effective Double Edge Triggered D Flip-Flop (DETDFF). Here an attempt has been made to construct an asynchronous micro pipeline using the proposed DETDFF with an aim to have ...

    Sensorless anti-swing control for automatic gantry crane system: model-based approach.(Report)

    Jan 01, 2007; Solihin, Mahmud Iwan ... Abstract To achieve a good control performance of automatic gantry crane system, sensors are indispensable instrument for feedback signals. However, sensing the payload motion of a real gantry crane, particularly swing motion, is troublesome and often costly. Therefore, ...

    Frequency-time MMSE equalizer for BER enhancement of MC-CDMA systems over mulipath fading channel.(bit error rate)(Multi-Carrier Code Division Multiple Access)(Report)

    Jan 01, 2007; Bouasria, F. ... Abstract This paper examines the performance of a multicarrier CDMA system over multipath fading channel. Due to the dispersive nature of the mobile communications channels, Multi-Carrier Code Division Multiple Access (MC-CDMA) signals will be affected by Inter Channel ...

    Influence of the operating parameters on the performance of belt skimmer.(Report)

    Jan 01, 2007; Kassab, Sadek Z. ... Abstract The present experimental study is dealing with the effect of varying the operating parameters on the performance of belt skimmer. The belt linear speed, belt inclination angle, and oil film thickness are the operating parameters considered in the present study. The ...

    Performance of fractionally spaced blind channel shortening.(Report)

    Jan 01, 2007; Elahmar, S.A. ... Abstract In this paper we derive the Multicarrier Equalization by Restoration of RedundancyY (MERRY) algorithm for a fractionally-spaced channel shortening (or time domain equalizer) (FSTEQ and show that the FSTEQ MERRY algorithm converges significantly faster than the ...

    Simulation of directly grid-connected wind turbines for voltage fluctuation evaluation.(Report)

    Jan 01, 2007; El-Tamaly, Hassan H. ... Abstract Power and voltage generated by a wind turbine are more variable than that produced by conventional generators. Therefore, with the increasing penetration of wind energy into the grid, it is very important to simulate precisely the wind turbine/grid interaction to ...

    Experimental investigation of Elliptical jet in coflow.(Report)

    Jan 01, 2007; Mebarka, Hakem ... Abstract The objective of the present study is to investigate systematically the mixing characteristics of an Elliptical jet with varying large aspect ratio in a co-flow current using experimental technique. Laser-Induced Fluorescence (LIF) technique is employed to measure the ...

    Optimal trajectory selection for a three DOF manipulator with minimum energy consumption.(Report)

    Jan 01, 2007; Ata, Atef A. ... Abstract Trajectory planning of redundant manipulator is a very active area since many tasks are requiring special characteristics to be satisfied. The importance of redundant manipulators has been increased for the last two decades because of the possibility to avoid ...

    An approach for surface reconstruction of 3D CAD models.(computer-aided design)(Report)

    Jan 01, 2007; Tiwari, Amod ... Abstract This paper proposes the algorithm to repair 3D artifact/model for which no data is available for the missing part. It presents an efficient healing algorithm that exploits information about the curvature (k) versus arc length (s) of the neighborhood point cloud data ...

    Diffusion-thermo and thermal-diffusion effects on free convective heat and mass transfer flow in a porous medium with time dependent temperature and concentration.(Report)

    Jan 01, 2007; Alam, M.S. ... Abstract The diffusion-thermo and thermal-diffusion effects on unsteady free convection and mass transfer flow along an accelerated vertical porous plate embedded in a porous medium have been studied numerically taking the plate temperature and concentration to be functions of ...

    Nonlinear dynamic analysis of thin shells using a finite element with drilling degrees of freedom.(Report)

    Jan 01, 2007; Djermane, M. ... Abstract The good performance of the mixed degenerate shell finite element with drilling degrees of freedom (DDSE) in linear and nonlinear static analysis problems is in the basis of the present work concerned with its extension to nonlinear dynamic regime. The 9-noded element ...

    Modelling AC Arcs developing along electrolytic surfaces simulating practical polluted insulator using an original laboratory model.(Report)

    Jan 01, 2007; Zegnini, Boubakeur ... Abstract The present paper comprises an experimental investigation into the prediction of the critical flashover voltage of polluted insulators energized with AC voltage using a multi-channel photo-multiplier (MCP) and high speed camera to observe the behavior of ac arc on ...

    Application of nonlinear sliding-mode control to permanent magnet synchronous machine:.(Study of the robustness)(Technical report)

    Jan 01, 2007; Kechich, A. ... Abstract This article is devoted to the study of the performances of the nonlinear order by sliding-mode with the integration of an integrator regulator, applied to the synchronous permanent magnet machine. In a first stage, we presented the design of the order by this new ...